Table of Contents
Advertisement
The setting screen for bottom face measurement region will be
displayed.
4.
Specify the starting line of the bottom
face measurement region.
Move the cursor with the Up and Down
Keys.
(Use these keys together with the SHIFT
Key to move the cursor quickly.)
The ending-line setting screen will be displayed.
5.
Repeat the procedure described in (4.)
to specify the ending line of the bottom
face measurement region.
The characteristic quantity setting screen will be displayed.
6.
Select a characteristic quantity that can
be used as the measurement point of
the bottom face.
The cross cursor of the measurement
point will move in response to the
selections.
Select the item while monitoring the image.
In this example, select Average.
The setting screen for top face measurement region will be displayed.
7.
Repeat (4.) through (6.) to set the
characteristic quantities of the top face
measurement region and measurement
point.
A confirmation message will be displayed.
8.
Select Execute.
The setting will be registered and the screen in (2.) will return.
SECTION 4
Menus for Expert Menu
Cursor
Cursor
Cursor
Average
Peak
Bottom
Back
Measrmnt items will be set.
OK?
Execute
Cancel
Back
Operation Manual
Z500
73
Advertisement
Table of Contents
Troubleshooting
