Step 4 Measurement Settings - Omron Z500 Operation Manual

SECTION 4
Menus for Expert Menu
4
Measurement Settings
Step
Set the measurement contents. Operational flow varies depending on the measurement item.
Setting Step: 2 pts, Edge position, and Define are taken as examples for description.
Operational Flow
#1
Page 70
Set Measurement
Items
When selecting Define :
CHECK
CHECK
#1
Set Measurement Items
Types of Measurement Item
Z500
70
Operation Manual
#2
Page 78 (if necessary)
Set Calibration
When not
selecting Define :
#2
Calibration setting is disabled.
Compensate the measurements under the output conditions given in
To use the position compensation function, set Compensatn and Meas set in this order.
The settings can be performed through the adjustment menu.
REFERENCE
Refer to page 28.
Up to eight measurement contents can be set for each scene.
There are 8 types of the measurement item. Different measurement item can be
set for each output number.
Selection
Height* Measure the height within the specified region.
Specify two measurement regions.
After taking the measurement point within the 1st region
Step: 2 pts as the reference, measure the distance from the mea-
surement point in the 2nd region.
Specify three measurement regions.
After taking the average of the measurement points
Step: 3 pts
within the two regions specified above, measure the
difference from the measurement point in the 3rd region.
Measures the specified edge position.
Edge position
#3
Page 84 (if necessary)
Set Output
Conditions
Description
Refer to page 72.
REFERENCE
Refer to page 74.
REFERENCE
*Height is set in OUT0 as the default setting.
Page 86
Changing
Measurement
Contents
Page 87
Clearing
Measurement
Items
#3.
Symbol