Setting Rs-232C Communications Specifications (Comm) - Omron Z500 Operation Manual

6-2 Setting RS-232C Communications Specifications (Comm)

This section describes the communications settings used for the RS-232C port.
The same communications settings must be used on both the Z500 and the external device.
Item
2400, 4800, 9600, 19200,
Baud rate
38400* bps
Data length 7, 8* bit
Parity bit None*, Even, Odd
Stop bits 1*, 2 bit
Delimiter CR*, LF, CR+LF
None*
RS/CS
Flow
Xon/Xoff
1.
Enter System Mode and select Comm.
Refer to page 144.
A setting screen will be displayed.
2.
Make the settings for each item.
3.
Select End.
The setting will be registered and the screen in (1.) will return.
REFERENCE
For details on I/O Format, refer to page 159.
Selection
REFERENCE
Description
Set the same settings that are set in the personal
computer.
Flow control is not performed.
Flow control performed by the hardware.
Use a cable that connects the Z500 and the RS signals
and CS signals from the external device. Data is sent
when the CS signal from the external device is ON.
Flow control performed by the software. Data is sent in
accordance with the Xon/Xoff code sent from the
external device.
The asterisk (*) indicates the default setting.
Scn 0 System
Comm
Environment
Download
Slant correct
Initialize
Ve rs io n
Scn 0
Baud rate
Data Length
Parity
Stop bits
Delimiter
Flow
SECTION 6
System Settings
System
:
38400bps
: 8bit
:
None
: 1bit
:
CR
: None
End
Z500
Operation Manual
145