Checking The Line Beam Position (Surrounding Image) - Omron Z500 Operation Manual

5-7 Checking the Line Beam Position (Surrounding image)

Displays images of the area surrounding the part that the line beam strikes. Whether or not the line beam
strikes the part required for measurement can be checked on the screen. This function is useful when the
Sensor is mounted inside an installation and the measurement area cannot be checked directly.
If the Z500-SW2 Sensor is connected, move the beam cover lever to the left.
CHECK
Refer to page 20, Setup Manual.
1.
Enter Tools Mode.
Refer to page 128.
The selections will be displayed.
2.
Select Surrounding image.
The sensor selections will be displayed.
Two Sensor
Select the number of the sensor used for
displaying the image.
The screen for recording images will be displayed.
3.
Press the TRIG Key.
An image of the area surrounding the line beam is displayed.
Z500-SW17: Displays the image for the shutter time displayed.
Z500-SW2: The Z500 will search for the most suitable shutter time and will display the image.
If the image is difficult to see clearly, adjust the image.
CHECK
Change the shutter speed using the Up and Down Keys.
Use these keys together with the SHIFT Key to move the cursor quickly.
Adjust the sensitivity level using the Left and Right Keys.
Image
Shutter time
Sensitivity level
Press the ENT Key to switch the lighting. (ON/OFF) (If the Z500-SW2 Sensor is
connected.)
4.
To stop displaying, press the ESC Key.
A Tools Mode screen will return.
REFERENCE
REFERENCE
Brighter
10s
31
Scn 0 Tools
Test
Surrounding image
Backup
Shutter=[ 0.01]s
Sensitivty=LV[ 11]
TRG:Get image
Darker
0.05s
0
SECTION 5
Other Functions
/ :Change
/ :Change
Z500
135
Operation Manual