Omron Z500 Operation Manual page 67

Profile measuring system
Hide thumbs Also See for Z500:
Table of Contents

Advertisement

Operational Flow
#1
To use the position compensation function, set Compensatn and Meas set in this order.
CHECK
#1
Registering the Reference Position
Register the position to be used for a reference for position compensation.
Before setting the necessary items, place the workpiece at the correct position.
In the example provided below, the procedure for compensating under the
following conditions is explained.
Reference height measurement point
#2
Page 65
Page 69
Set the
Registering
Compensation
the Reference
Method
Position
Reference height
Measurement
point (Average)
Selection
Define the average profile position within a specified region as the
Average
measurement point.
Define the peak profile position within a specified region as the
Peak
measurement point.
Define the bottom profile position within a specified region as the
Bottom
measurement point.
Peak
Bottom
Region
Menus for Expert Menu
Reference position
Region
Measurement
point (Edge position)
Edge level
Description
SECTION 4
Z500
65
Operation Manual

Advertisement

Table of Contents

Troubleshooting

loading

This manual is also suitable for:

Z500-mc15eZ500-mc10e

Table of Contents