Step 7 Performing Measurement - Omron Z500 Operation Manual

7
Performing Measurement
Step
Perform the measurement under the conditions that have been previously set.
Use the following procedure to execute measurement according to the
conditions set for the scene currently displayed.
The data will be output to external devices as well.
1.
Confirm that Run
If Run
ESC Key several times to switch the
selection.
Measurement will be executed and the measurement results
will be displayed on the screen.
Check that measurement has been performed correctly.
Conditions can be changed simply without leaving Run Mode using the adjustment menu.
CHECK
Measurement will be interrupted while adjustments are made.
Refer to page 28.
Change the Monitors using the SHIFT + Right Keys or SHIFT + Left Keys if necessary.
CHECK
Refer to page 29.
For measurements through the execution of Force-zero
CHECK
Refer to page 110.
is selected.
is not selected, press the
REFERENCE
REFERENCE
REFERENCE
SECTION 4
Menus for Expert Menu
The output number for the currently
displayed measurement result is displayed.
Scn 0 Run
NEAR
BRIGHT
DARK
OUT 0
+0005.18800
S+ / :Display S+ENT:Adjust
Measurement value
Operation Manual
9.96ms
FAR
Sen0
[ 31]
LV
[ 50]
PEAK
Sen1
[ .]
LV
[ ]
PEAK
Zero's OFF
mm PASS
Judgement result
Z500
107