#2
Position the Workpiece and Adjust the Image
Position the workpiece to be measured and adjust the displayed image in the
measurement range.
The measurement range varies depending on the Sensor models connected.
Refer to page 26 in the Setup Manual.
Example: Z500-SW17
+20mm
Height
-20mm
1.
Position the workpiece.
In this example, the workpiece shown in
the right figure will be described.
REFERENCE
Sensor
100mm
Measurement range
0mm
Position
+20mm
0mm
-20mm
14.5mm
(±7.25mm)
17.3mm
(±8.65mm)
20.1mm
(±10.05mm)
SECTION 2
Basic Operations
Z500
21
Operation Manual