Step 6 Starting Measurements - Omron Z500 Operation Manual

6
Starting Measurements
Step
Perform the measurement under the conditions that have been previously set.
Use the following procedure to execute measurement according to the conditions set for the scene
currently displayed.
The data will be output to external devices as well.
1.
Confirm that Run
If Run
selection.
Measurement will be executed and the measurement results will
be displayed on the screen. Check that measurement has been
performed correctly.
Conditions can be changed simply without leaving Run Mode using the
CHECK
adjustment menu.
Measurement will be interrupted while adjustments are made.
Refer to page 28.
Change the Monitors using the SHIFT + Right Keys or SHIFT + Left Keys if
CHECK
necessary.
Refer to page 29.
For measurements through the execution of Force-zero
CHECK
Refer to page 110.
is selected.
is not selected, press the ESC Key several times to switch the
REFERENCE
REFERENCE
REFERENCE
SECTION 3
Menus for Conversational Menu
The output number for the currently displayed
measurement result is displayed.
Scn 0 Run
NEAR
BRIGHT
DARK
OUT 0
+0005.18800
S+ / :Display S+ENT:Adjust
Measurement value Judgment result
Operation Manual6
9.96ms
FAR
Sen0
[ 15]
LV
[ 170]
PEAK
Sen1
[ .]
LV
[ ]
PEAK
Zero's OFF
mm PASS
Z500
51