Rs-232C - Omron Z500 Operation Manual

7-2 RS-232C

The Z500 can perform no-protocol communications with an external device, such as a personal
computer, via RS-232C. The same communications settings must be used on both the Z500 and the
external device.
For details on setting communications specifications, refer to page 145.
Commands can be input only when the Z500 is in Run Mode. Do not use the terminal
CHECK
blocks for input or output during command execution.
At least 100 ms is required to output a measurement result after receiving a command via
RS-232C.
Communications Overview
REFERENCE
Z500
Z500
MULTI-DIMENSION CONTROLLER
(Run Mode)
Execute command
Measurement is stopped during command execution.
Output result
SECTION 7
I/O Format
Computer
Input command
Receive result
Z500
Operation Manual
159