4.2.5 Changing the setting value
There are two specification types: the selection type to select among the predetermined
options, and to input the numeric value.
(1) Changing the setting value of the selection type (Example: Changing
CYCLE)
Press the MODE key several times to enter FUN mode, and then press the ▼ or ▲ key to
display CYCLE.
Display (upper
line/ lower line)
CYCLE
10 s
↓
SET/REC/STOP key
CYCLE
10 s
↑ blinks
↓
▼ or ▲ key
CYCLE
30 s
↑ blinks
↓
SET/REC/STOP key
CYCLE
30 s
After the settings above, has done, the setting items can be changed again with the ▼ or ▲
key, and the operation mode can be changed with the MODE key as well.
Press the MODE key repeatedly until "FUN" will blink. Press the ▼ or ▲
key to display CYCLE in the upper line of the display.
When pressing the SET/REC/STOP key, the value in the lower line
blinks.
Settable values are displayed in sequence by pressing the ▼ or ▲ key.
When pressing the MODE key, the setting is cancelled.
Press the ▼ or ▲ key to display the desired value, and then press the
SET/REC/STOP key.
The value will be confirmed and blinking will stop.
4-11
4. Setting the Unit (Unit Operation)
Operation