INVT SV-DA200 Operation Manual page 144

SV-DA200 series AC servo drives
1
Data size
P3.74
Modbus address
Voltage protection of
P3.75
analog input 3
This parameter is used to set the overvoltage protection value of analog input 3.
If the absolute value of analog input 3 voltage exceeds the set value, the system will report
alarm.
Data size
P3.75
Modbus address
P3.76 Analog input 3 filter
This parameter is used to set the time constant of first order low-pass filter of analog input 3.
Data size
P3.76
Modbus address
Deadzone mode of
P3.77
analog input
Set the deadzone voltage mode of analog input by this parameter
Setting value
[0]
1
Data size
P3.77
Modbus address
P3.90 Pulse input filter
This parameter is used to set filter time of the pulse input.
Setting value
Negative
[+voltage] → [negative],[- voltage] → [positive]
polarity
Normal mode
CNC mode. When AI is smaller than the deadzone, the valid value is 0:
When AI is larger than the deadzone, the valid value is AI-deadzone.
1754, 1755
0 400kHz
1 500kHz
[2] 1MHz
3 2MHz
4 4MHz
5 >4MHz
6 200kHz
7 100kHz
16bit
1748,1749 CANopen address
Setting range Default
0.000~10.000 0.000
32bit
1750,1751 CANopen address
Setting range Default
0.0~1000.0
16bit
1752,1753 CANopen address
Setting range Default
0~1
Definition
16bit
CANopen address
Setting range Default
0~7
Width of pulse input
‐134‐
Faults and solutions
Data format
Unit
V
Data format
Unit
0.0 ms
Data format
Unit
0 -
Data format
Unit
2 -
DEC
0x234A,0x00
Available mode
P S T F
DEC
0x234B,0x00
Available mode
P S T F
DEC
0x234C,0x00
Available mode
P S T F
LIST
0x234D, 0x00
Available mode
P S T F