7
MES INTERFACE FUNCTION CONFIGURATION TOOL
7.6.4 Setting items in DB buffering setting
Configure the settings for the DB buffering function.
For the DB buffering function setting, refer to the following:
Section 6.1.10 DB buffering function
(1) DB buffering status
(a) Select a tag component into which whether data are currently accumulated in the
(b) Data are stored as follows depending on the data type.
(2) No. of DB bufferings
(a) Select a tag component into which whether data are currently accumulated in the
(b) Data are stored as follows depending on the data type.
Figure 7.26 [DB buffering settings]
DB buffer or not is stored.
Note that the following tags are not selectable.
• Tags for which [Prohibit data writing] is enabled
• Tags for which [Array setting] is set.
Table 7.27 Values stored in [DB buffering status]
Data type of tag
component
OFF: Not accumulated
Bit
ON: One or more data accumulated
0: Not accumulated
Other than the above
1: One or more data accumulated
DB buffer or not is stored.
Note that the following tags are not selectable.
• Tags for which [Prohibit data writing] is enabled
• Tags for which [Array setting] is set.
Table 7.28 Values stored in [No. of DB bufferings]
Data type of tag
component
OFF: Not accumulated
Bit
ON: One or more data accumulated
0: Not accumulated
Other than the above
1 or greater: Number of buffering data that are accumulated
Description
Description
7.6 System Setting
7.6.4 Setting items in DB buffering setting
1
2
3
4
5
6
7
8
7
- 27