Mitsubishi Electric Melsec Q Series User Manual page 102

4
SETTINGS AND PROCEDURE TO OPERATION
4
- 5 4.2 Settings and Procedure to Operation
*1 As necessary, execute the self-diagnostic test for checking the communication function and
hardware of the MES interface module.
Section 4.6 Self-diagnostics Test
*2 For a battery, refer to the following:
Section 4.8 Battery
Section 4.9 Operation without Mounting Battery
Section 4.10 Removing Battery for Storage
*3 If an account is forgotten and therefore connection to the MES interface module cannot be made,
eject the CompactFlash card from the MES interface module, then follow the procedure in the
*3
figure above and subsequent procedure.
For details on how to eject the CompactFlash card, refer to the following.
Section 4.7.2 Installation/removing the CompactFlash card
*4 For details on how to insert/eject the CompactFlash card and precautions for use, refer to the
following.
Section 4.7 CompactFlash Card
*5 When the test has been completed abnormally, check the following and execute the PING
command again.
• Network settings for the MES interface module or configuration computer
• Connection status of the MES interface module or configuration computer