4
SETTINGS AND PROCEDURE TO OPERATION
4.10 Removing Battery for Storage
When storing the QJ71MES96 MES interface module without mounting a battery, make
sure to perform the shutdown operation, then power OFF the programmable controller and
remove the battery.
File access stop request (Y2)
File access status (X2)
4
- 25
4.10 Removing Battery for Storage
Not doing so may cause the data corruption in the CompactFlash card being
accessed or a file system error.
(a) Operation procedure
1
Mount the programmable controller CPU and QJ71MES96 MES interface module
on the base unit and power ON the programmable controller CPU.
2
Stop file access.
(Turn the File access stop request (Y2) ON from OFF.)
3
Confirm that file access has stopped.
(Check the File access status (X2) is turned ON.)
4
Power OFF the programmable controller CPU.
5
Remove the battery from the QJ71MES96 MES interface module.
(In operation)
Figure 4.20 Removing battery for storage
(During stop)
Power OFF the programmable controller and remove the battery.