Mitsubishi Electric Melsec Q Series User Manual page 275

7
MES INTERFACE FUNCTION CONFIGURATION TOOL
(1) Procedure name (Up to 32 characters)
Set a stored procedure name of the database to be accessed.
For characters that can be used for stored procedure names, refer to the following:
procedure names,etc.
For browsing the stored procedure names in the database, refer to the following:
(2) Browse
Clicking the
box. Select a stored procedure name. The selected stored procedure name is set on
the [Communication action] dialog box by clicking the
Up to 1024 stored procedures can be displayed.
The following stored procedure names in the database are not displayed.
• An inapplicable character is included in [Stored procedure name] of the MES
• The number of characters exceeds 32.
• The number of arguments exceeds 256.
When the target stored procedure name is not displayed, enter the stored procedure
name manually to [Procedure name] in the [Communication action] dialog box.
Appendix 2.4 Characters available for field names, table names, stored
(2) Browse procedure name in this section
procedure name
Browse procedure name
Figure 7.92 Browsing example of [Stored procedure list]
Interface Function Configuration Tool.
( Appendix 2.4 Characters available for field names, table names, stored
procedure names,etc.)
7.11.3 Setting items in Communication action (Stored procedure)
button displays the [Stored procedure list] dialog
button.
OK
7.11 Job Setting - Actions
1
2
3
4
5
6
7
8
7
- 117