Mitsubishi Electric Melsec Q Series User Manual page 66

3
SPECIFICATIONS
Network communication
route
CC-Link
C24
3
- 7 3.2 Accessible Devices and Ranges
Table 3.5 Single network
*7
QCPU (Q mode) RCPU
*1 For the network No. and the station number, set the same values as that set in the parameter
settings of the access target module. (The parameter of an Ethernet module or the MELSOFT
connection extended setting of QCPU (Q mode))
In addition, set the parameter in "Station No. <-> IP information" in the parameter settings of the
access target module. For the [Station No. <-> IP information], specify the IP address computation
method, table conversion method, or both.
*2 For the QnACPU and QE71 on the access target CPU side, use products of the manufacturing
date 9707B or later.
*3 For the CC-Link system master/local module on the access target CPU side, use modules of
software version "S" or later.
*4 Use a MES interface module whose serial No. (first five digits) is "13092" or later.
*5 Use Universal model QCPU whose serial No. (first five digits) is "12012" or later.
*6 When a C Controller module is used as a control CPU of the access target network module, the
accessible CPU module is only the control CPU.
*7 Use QCPU (Q mode) or RCPU as a control CPU of the access target network module.
*8 Use an Ethernet module or the built-in Ethernet port of QCPU (Q mode), which is set the
MELSOFT connection extended setting, to access a programmable controller CPU via Ethernet.
When using the built-in Ethernet port of QCPU (Q mode) which is set the MELSOFT connection
extended setting, use MES interface module whose serial No. (first five digits) is "17122" or later.
The Ethernet port of MES interface module cannot be used.
*9 When the access target CPU is Q12DCCPU-V, the access is not possible.
*10 Use a MES interface module whose serial No. (first five digits) is "15102" or later.
*11 Use a MES interface module whose serial No. (first five digits) is "16072" or later.
*12 When the Network communication route is NET/10(H), the access is not possible.
Access target CPU (PLC series)
*11
LCPU QnACPU
*3
QCPU (A mode), C Controller
ACPU module
*3
×
: Accessible ×: Inaccessible
*6
×