Mitsubishi Electric Melsec Q Series User Manual page 101

4
SETTINGS AND PROCEDURE TO OPERATION
(From the previous page)
Power OFF the programmable controller.
According to [Network settings], connect the MES interface module and configuration computer to a network.
Section 2.1.4 System configuration for operation
Power ON the programmable controller.
MES interface module
When changing
the settings
Operation
Figure 4.2 MES interface module start-up procedure
(From the previous page)
Set the target MES interface module.
Write a project to the MES interface module.
• Section 7.12.1 Setting the target MES interface
module
• Section 7.12.2 Writing the MES interface
function settings
Configuration computer
Check communications with the MES interface module by
executing the PING command in the command prompt
screen.
*5
Configure the settings in MES Interface Function
Configuration Tool for the MES interface function.
• Chapter 6 FUNCTIONS
• Section 7.6 System Setting
• Section 7.7 Access Target CPU Setting
• Section 7.8 Device Tag Setting
• Section 7.9 Server Service Setting
• Section 7.10 Job Setting
• Section 7.11 Job Setting - Actions
Set the target MES interface module.
Write the project to the MES interface module.
• Section 7.12.1 Setting the target MES interface
module
• Section 7.12.2 Writing the MES interface
function settings
4.2 Settings and Procedure to Operation
1
2
3
4
5
6
7
8
4
- 4