Changing The Job Status - Mitsubishi Electric Melsec Q Series User Manual

7
MES INTERFACE FUNCTION CONFIGURATION TOOL

7.13.4 Changing the job status

The job status can be changed.
1
2
The job status changed by this operation returns to the status set in [Job settings]
by performing any of the following operations.
• Perform [Update settings]
Section 7.13.2 (3) Update settings
• Power OFF and then ON
• Reset the programmable controller CPU
Figure 7.109 [Change job status]
From [Job List], select the job whose status is to be changed.
Select a checkbox of the status to be changed.
Table 7.96 Selection items of [Change job status]
Item
Enable job
*1
Enable startup logging
*2
Enable detailed logging
Disable writing to PLC
device
Disable writing to database
Description
• Checked
The job is enabled and thereby it is executed when the trigger
conditions are met.
• Not checked
The job is disabled, and thereby it is not executed even if the
trigger conditions are met.
• Checked
The startup logging is enabled, and thereby startup records are
logged.
• Not checked
The startup logging is disabled, and thereby startup records are
not logged.
• Checked
The detailed logging is enabled, and thereby detailed records are
logged.
• Not checked
The detailed logging is disabled, and thereby detailed records are
not logged.
• Checked
Writing to programmable controller devices is disabled.
• Not checked
Writing to programmable controller devices is enabled.
*3
• Checked
Writing to the database is disabled.
• Not checked
Writing to the database is enabled.
7.13 Online - Remote operation
7.13.4 Changing the job status
1
2
3
4
5
6
7
8
7
- 141