Performing Non-Destructive Testing In Mode Empty-Full - RADWAG WLY User Manual

Caution:
A pattern and example of the report from testing products are described in ch.
30.14 of this manual. A pattern and example of the report from estimating
average tare are described in ch. 30.13 of this manual.

30.9. Performing non-destructive testing in mode Empty-Full

For mode „Non-destructive Empty-Full" a user sets the measurement
"charge" in the product data. According to the set „charge" a message
is shown that informs about putting empty packages first and then the
same packages after they have been filled up in the same sequence:
Where:
Product
Code
Net
Name of the controlled product
-
Code of the controlled product
-
Nominal value of the controlled product
-
Average mass of the controlled product
-
Value of the disqualifying average
-
Characteristics of negative errors T1 in a sample
-
(in accordance with ch. 30.6 of this manual)
Characteristics of negative errors 2T1 in a sample
-
(in accordance with ch. 30.6 of this manual)
- Net mass of the controlled product
165