Configuration Of Outputs - RADWAG WLY User Manual

18.2. Configuration of outputs

Ascribing a function to the output enables the output at the same time.
If an output has no ascribed function it is disabled.
Procedure:
• Enter <
• Choose <
will see the list of functions:
None
Stabile
MIN stable
MIN non-stable
OK stable
OK non-stable
MAX stable
MAX non-stable
Zero
Confirmation of
cycle completion *
Zero
! OK unstable
! OK stable
Measurement
saved
Tarring completed
Zeroing completed
Error
PGC – pending
weighing process
Inputs / Outputs> according to ch. 18 of this manual,
Outputs> and enter the required output, then you
Output disabled
Stable weighing result over LO threshold value
Stable weighing result below the MIN threshold
Non-stable weighing result below the MIN threshold
Stable weighing result between MIN and MAX
thresholds
Non-stable weighing result between MIN and MAX
thresholds
Stable weighing result over the MAX threshold
Non-stable weighing result over the MAX threshold
Stable weighing result zero net
Signal that confirms that a cycle of dosing has been
completed (the defined amount)
Zero weighing result („zero" indication)
Unstable weighing result out of OK threshold
Stable weighing result within OK threshold
Signal for measurement record confirmation -
OUT programmed to be active for 500 [ms]
Signal for tarring operation confirmation -
OUT programmed to be active for 500 [ms]
Signal for zeroing operation confirmation -
OUT programmed to be active for 500 [ms]
Error message displayed
Signal for awaiting for weighing performed within
PGC control process
84