Utomatic Correction Of Reference Mass - RADWAG WLY User Manual

26.2.1. Automatic correction of reference mass
Working mode <
< Automatic correction of reference mass>, that can be used for
correcting the unit mass <SMP>. To enable the function in parameters you
need to:
• Enter parameter group <
24 of this manual, choose: „
correction of reference mass" and set appropriate option.
Options:
-
-
Function < Automatic correction of reference mass> in mode
< Parts counting > is enabled at the moment of estimating the sample
quantity and signalled by displaying <PCS> and <SMP> (single part/piece
mass) on the top part of the display.
There are four criteria of working "Automatic correction of reference
mass" function:
1. equilibrium should be reached,
2. quantity of parts/pieces should be increased,
3. added quantity of parts/pieces should not be greater than double
number of parts/pieces on the pan,
4. the new sample can be different from the old sample by ± 0.3
of pcs (absolute value),
If a user recognises that the sample quantity is adequate the unit mass
(single piece mass) can be saved (see ch. 26.6 of this manual)
and disable the function by pressing
Parts counting> comprises a special function
Automatic correction of reference mass disabled
Automatic correction of reference mass enabled
It concerns the <
Working modes> according to ch.
Parts counting /
.
121
Parts counting> working mode
Automatic