25.2. Local setting of a working mode
Local setting of a working mode <
a hot key <
Local parameters>:
Save Mode
Down-weighing
Checkweighing
Tare mode
Labelling mode
Statistics
Differential weighing
Peak hold
Information abort
saved measurement
Ingredient weight
entered manually
26. WORKING MODES – PARTS COUNTING
Parts counting is working mode allowing to count pieces on the basis of the
standard unit mass of a single piece set on the scale or fetched from the
database.
Caution:
If parts counting is performed in an additional container it should be tarred.
26.1. Starting the working mode
Procedure:
• While in the main window press
see a submenu <Working Modes> comprising a list of modes,
Weighing> are accessible on pressing
Detailed description in ch. 24.2 of the user manual
Detailed description in ch. 24.3 of the user manual
Detailed description in ch. 24.4 of the user manual
Detailed description in ch. 24.5 of the user manual
Detailed description in ch. 24.6 of the user manual
Detailed description in ch. 24.7 of the user manual
Detailed description in ch. 24.8 of the user manual
Detailed description in ch. 24.9 of the user manual
Detailed description in ch. 24.10 of the user manual
Detailed description in ch. 24.11 of the user manual
in the top bar, then you will
119