Table of Contents
Advertisement
3. Barcode scanners can send additional information apart from the
expected barcode e.g. symbology (type of barcode). It is advisable
to disable such information because RADWAG devices and
software do not use it.
4. Some RADWAG systems can omit unnecessary information by
using parameters that mark the beginning and the length of the
code required to analyse.
5. A special protocol is required in order the code be received by
RADWAG equipment. It is required to program an appropriate
prefix and suffix. Prefix – one byte 01 hexadecimally, suffix one
byte 0D hexadecimally.
6. Most barcode scanners allow to enable/disable different
symbologies (barcode types).
7. Programming of scanners is usually performed by reading
special barcodes or by using an external software tool.
8. Scanners marketed together with RADWAG systems are
always configured according to the rules above.
Barcode with required prefix and
suffix in hexadecimal format
01 30 30 32 31 30 31 32 36 0D
01 30 31 32 33 34 35 36 37 38 39 0D
01 43 4F 44 45 20 33 39 20 54 45 53 54 0D
01 31 31 30 31 32 33 34 35 36 37 38 39 31 0D
01 43 6F 64 65 20 31 32 38 20 54 65 73 74 0D
50. APPENDIX G – Computer Program „PGC Viewer"
Computer program „PGC Viewer" is intended for viewing and printing reports
from controls and average tare tests.
Caution:
Installation program „PGC Viewer" is recorded on the CD connected to this
product.
Barcode without
required –fixes in
ASCII format
00210126
0123456789
CODE 39 TEST
1101234567891
CODE 128 Test
301
Code type
EAN-8
2 of 5
CODE 39
EAN-13
CODE 128
Advertisement
Table of Contents
