Table of Contents
Advertisement
Tare
Status
Put Empty 1/10
(1/3)
After the test has been completed the test is summarized (see ch. 30.8)
and the results are automatically saved in the database.
Caution:
A pattern and example of the report from estimating average tare are
described in ch. 30.14 of this manual.
30.10. Performing destructive testing in modes Empty-Full and
Full-Empty
"Destructive" control process complying with the regulation, and
independently on the batch size that exceeds 100 pcs., the size of a sample
accepted by the software for control process is 20 pcs. Other control criteria
are accepted as specified in the regulation.
After selecting from a list a product with set options for the destructive control
with determined measuring "lot", and starting the control process, the
software will display messages facilitating the control process (as in the case
of control process described above).
Depending on the set control mode, the scale orders the following sequence
of weighing products: "empty-full" or "full-empty".
Caution:
Remember to maintain the order for weighing products with packages and
empty packages. It is important to the software that carries out mass
calculations of products placed in a specific packaging.
-
Tare of the packaging
-
Control status (in accordance with ch. 30.6)
-
Commands on control process
Value of the measuring lot
Data on a control process in progress (in
-
accordance with ch. 30.6 of this manual)
Change of the workspace: numerical data / chart
-
(in accordance with ch. 30.6 of this manual)
-
Control completion
166
Advertisement
Table of Contents
