General Configuration - Edge-Core AS6700-32X Cli Reference Manual

General Configuration

router ospf
Table 167: Open Shortest Path First Commands
Command
ip ospf priority
ip ospf retransmit-interval
ip ospf transmit-delay
passive-interface
Display Information
show ip ospf
show ip ospf border-routers
show ip ospf database
show ip ospf interface
show ip ospf neighbor
show ip ospf route
show ip ospf virtual-links
show ip protocols ospf
This command enables Open Shortest Path First (OSPFv2) routing for all IP
interfaces on the router and enters router configuration mode. Use the no form to
disable OSPF for all processes or for a specified process.
Syntax
[no] router ospf [process-id]
process-id - Process ID must be entered when configuring multiple routing
instances. (Range: 1-65535; Default: 1)
Command Mode
Global Configuration
Default Setting
No routing process is defined.
Command Usage
◆
OSPF is used to specify how routers exchange routing table information.
◆
This command is also used to enter router configuration mode.
◆
If the process ID is not defined, the default is instance 1.
Function
Sets the router priority used to determine the designated
router
Specifies the time between resending a link-state
advertisement
Estimates time to send a link-state update packet over an
interface
Suppresses OSPF routing traffic on the specified interface
Displays general information about the routing processes PE
Displays routing table entries for Area Border Routers (ABR)
and Autonomous System Boundary Routers (ASBR)
Shows information about different LSAs in the database
Displays interface information
Displays neighbor information
Displays the OSPF routing table
Displays parameters and the adjacency state of virtual links PE
Displays OSPF process parameters
– 839 –
Chapter 29
| IP Routing Commands
Open Shortest Path First (OSPFv2)
(Continued)
Mode
IC
IC
IC
RC
PE
PE
PE
PE
PE
PE