General Configuration - Edge-Core AS6700-32X Cli Reference Manual

Chapter 29
| IP Routing Commands
Border Gateway Protocol (BGPv4)

General Configuration

router bgp
Table 185: Border Gateway Protocol Commands – Version 4
Command
show ip bgp prefix-list
show ip bgp regexp
show ip bgp route-map
show ip bgp scan
show ip bgp summary
show ip community-list
show ip extcommunity-list
show ip prefix-list
show ip prefix-list detail
show ip prefix-list summary
show ip protocols bgp
This command enables the Border Gateway Protocol (BGPv4) routing process and
enters router configuration mode. Use the no form to disable it.
Syntax
[no] router bgp as-number
as-number – Autonomous system number which identifies this router as a
member of the specified domain, and tags routing messages passed to
other BGP routers with this number. (Range: 1-4294967295)
Command Mode
Global Configuration
Default Setting
No routing process is defined.
Command Usage
◆
To enable BGP routing, you must use this command to establish a BGP routing
process. After entering this command, the switch enters router configuration
mode.
◆
AS numbers in the range 64512-65535 are normally used for private routing
domains, and can be removed from the AS path attribute in outbound routing
messages using the
number 23456 is reserved for the AS-Transitive attribute which is required
when setting up a new BGP speaker.
Function
Shows routes matching the specified prefix-list
Shows routes matching the AS path regular expression
Shows routes matching the specified route map
Shows BGP scan status
Shows summary information for all connections
Shows routes permitted by a community list
Shows routes permitted by an extended community list
Shows the specified prefix list
Shows detailed information for the specified prefix list
Shows summary information for the specified prefix list
Displays BGP process parameters
neighbor remove-private-as
– 922 –
(Continued)
Mode
PE
PE
PE
PE
PE
PE
PE
PE
PE
PE
PE
command. Note that AS