Show Lldp Config - Edge-Core AS6700-32X Cli Reference Manual

◆
◆
Example
Console(config)#interface ethernet 1/1
Console(config-if)#lldp notification
Console(config-if)#

show lldp config

This command shows LLDP configuration settings for all ports.
Syntax
Command Mode
Privileged Exec
Example
Console#show lldp config
LLDP Global Configuation
LLDP Port Configuration
notifications include information about state changes in the LLDP MIB (IEEE
802.1AB), or organization-specific LLDP-EXT-DOT1 and LLDP-EXT-DOT3 MIBs.
SNMP trap destinations are defined using the
Information about additional changes in LLDP neighbors that occur between
SNMP notifications is not transmitted. Only state changes that exist at the time
of a trap notification are included in the transmission. An SNMP agent should
therefore periodically check the value of lldpStatsRemTableLastChangeTime to
detect any lldpRemTablesChange notification-events missed due to throttling
or transmission loss.
show lldp config [detail interface]
detail - Shows configuration summary.
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
LLDP Enabled
LLDP Transmit Interval
LLDP Hold Time Multiplier
LLDP Delay Interval
LLDP Re-initialization Delay : 2 sec.
LLDP Notification Interval
LLDP MED Fast Start Count
Port Admin Status Notification Enabled
-------- ------------ --------------------
Eth 1/1 Tx-Rx True
Eth 1/2 Tx-Rx True
– 673 –
Chapter 23
snmp-server host
: Yes
: 30 sec.
: 4
: 2 sec.
: 5 sec.
: 4
| LLDP Commands
command.