Rmon Collection Rmon1 - Edge-Core AS6700-32X Cli Reference Manual

◆
◆
Example
Console(config)#interface ethernet 1/1
Console(config-if)#rmon collection history controlentry 21 buckets 24
Console(config-if)#
rmon collection
This command enables the collection of statistics on a physical interface. Use the
no form to disable statistics collection.
rmon1
Syntax
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet)
The information collected for each sample includes:
input octets, packets, broadcast packets, multicast packets, undersize packets,
oversize packets, fragments, jabbers, CRC alignment errors, collisions, drop
events, and network utilization.
The switch reserves two controlEntry index entries for each port. If a default
index entry is re-assigned to another port by this command, the
config command will display a message indicating that this index is not
available for the port to which is normally assigned.
For example, if control entry 15 is assigned to port 5 as shown below, the show
running-config command will indicate that this entry is not available for port
8.
Console(config)#interface ethernet 1/5
Console(config-if)#rmon collection history controlEntry 15
Console(config-if)#end
Console#show running-config
!
interface ethernet 1/5
rmon collection history controlEntry 15 buckets 50 interval 1800
...
interface ethernet 1/8
no rmon collection history controlEntry 15
interval 60 owner mike
rmon collection rmon1 controlEntry index [owner name]
no rmon collection rmon1 controlEntry index
index – Index to this entry. (Range: 1-65535)
name – Name of the person who created this entry.
(Range: 1-127 characters)
– 207 –
Chapter 6
| Remote Monitoring Commands
show running-