Edge-Core AS6700-32X Cli Reference Manual page 289

Default Setting
VLAN-Unit-Port
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
◆
DHCP provides a relay mechanism for sending information about the switch
and its DHCP clients to the DHCP server. DHCP Option 82 allows compatible
DHCP servers to use the information when assigning IP addresses, to set other
services or policies for clients. For more information of this process, refer to the
Command Usage section under the
command.
◆
Option 82 information generated by the switch is based on TR-101 syntax as
shown below:
Table 55: Option 82 information
82 3-69
opt82 opt-len sub-opt1 string-len
The circuit identifier used by this switch starts at sub-option1 and goes to the
end of the R-124 string. The R-124 string includes the following information:
sub-type - Distinguishes different types of circuit IDs.
■
sub-length - Length of the circuit ID type
■
access node identifier - ASCII string. Default is the MAC address of the
■
switch's CPU. This field is set by the
command,
eth - The second field is the fixed string "eth"
■
slot - The slot represents the stack unit for this system.
■
port - The port which received the DHCP request. If the packet arrives over
■
a trunk, the value is the ifIndex of the trunk.
vlan - Tag of the VLAN which received the DHCP request.
■
Note that the sub-type and sub-length fields can be enabled or disabled
using the ip dhcp snooping information option
The ip dhcp snooping information option circuit-id command can be
■
used to modify the default settings described above.
Chapter 8
ip dhcp snooping information option
1 1-67 x1
ip dhcp snooping information option
– 289 –
| General Security Measures
DHCPv4 Snooping
x2 x3 x4 x5
R-124 string
command.
x63