Snmp Target Host Commands - Edge-Core AS6700-32X Cli Reference Manual

10g/40g top-of-rack switches
Hide thumbs Also See for AS6700-32X:
Table of Contents

Advertisement

Chapter 5
| SNMP Commands

SNMP Target Host Commands

SNMP Target Host Commands
snmp-server enable
traps
This command enables this device to send Simple Network Management Protocol
traps or informs (i.e., SNMP notifications). Use the no form to disable SNMP
notifications.
Syntax
[no] snmp-server enable traps [authentication | ethernet cfm |
mac-notification [interval seconds]]
authentication - Keyword to issue authentication failure notifications.
ethernet cfm - Connectivity Fault Management traps. For more
information on these traps, see
mac-notification - Keyword to issue trap when a dynamic MAC address is
added or removed.
interval - Specifies the interval between issuing two consecutive traps.
(Range: 1-3600 seconds; Default: 1 second)
Default Setting
Issues authentication and link-up-down traps.
Other traps are disabled.
Command Mode
Global Configuration
Command Usage
If you do not enter an snmp-server enable traps command, no notifications
controlled by this command are sent. In order to configure this device to send
SNMP notifications, you must enter at least one snmp-server enable traps
command. If you enter the command with no keywords, both authentication
and link-up-down notifications are enabled. If you enter the command with a
keyword, only the notification type related to that keyword is enabled.
The snmp-server enable traps command is used in conjunction with the
snmp-server host
command. Use the
which host or hosts receive SNMP notifications. In order to send notifications,
you must configure at least one
The authentication, link-up, and link-down traps are legacy notifications, and
therefore when used for SNMP Version 3 hosts, they must be enabled in
conjunction with the corresponding entries in the Notify View assigned by the
snmp-server group
Example
Console(config)#snmp-server enable traps link-up-down
Console(config)#
"CFM Commands" on page
snmp-server host
snmp-server host
command.
– 186 –
681.
command to specify
command.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

As5700-54x

Table of Contents