Switchport Acceptable-Frame-Types - Edge-Core AS6700-32X Cli Reference Manual

Example
The following example shows how to set the interface configuration mode to
VLAN 1, and then assign an IP address to the VLAN:
Related Commands
shutdown (364)
interface (360)
vlan (473)
switchport
This command configures the acceptable frame types for a port. Use the no form to
restore the default.
acceptable-frame-
types
Syntax
Default Setting
All frame types
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
When set to receive all frame types, any received frames that are untagged are
assigned to the default VLAN.
Example
The following example shows how to restrict the traffic received on port 1 to
tagged frames:
Related Commands
switchport mode (479)
Console(config)#interface vlan 1
Console(config-if)#ip address 192.168.1.254 255.255.255.0
Console(config-if)#
switchport acceptable-frame-types {all | tagged}
no switchport acceptable-frame-types
all - The port accepts all frames, tagged or untagged.
tagged - The port only receives tagged frames.
Console(config)#interface ethernet 1/1
Console(config-if)#switchport acceptable-frame-types tagged
Console(config-if)#
– 475 –
Chapter 18
| VLAN Commands
Configuring VLAN Interfaces