Mep Fault-Notify Lowest-Priority - Edge-Core AS6700-32X Cli Reference Manual

more defects indicated, and fault alarms are enabled at or above the priority level
set by the
Example
This example set the delay time before generating a fault alarm.
Console(config)#ethernet cfm domain index 1 name voip level 3
Console(config-ether-cfm)#mep fault-notify alarm-time 10
Console(config-ether-cfm)#
mep fault-notify
This command sets the lowest priority defect that is allowed to generate a fault
lowest-priority alarm. Use the no form to restore the default setting.
Syntax
Default Setting
Priority level 2
Command Mode
CFM Domain Configuration
Command Usage
◆
◆

mep fault-notify lowest-priority

mep fault-notify lowest-priority priority
no fault-notify lowest-priority
priority – Lowest priority default allowed to generate a fault alarm.
(Range: 1-6)
A fault alarm can generate an SNMP notification. It is issued when the MEP fault
notification generator state machine detects that a configured time period (see
the mep fault-notify alarm-time
defects indicated, and fault alarms are enabled at or above the priority level set
by this command. The state machine transmits no further fault alarms until it is
reset by the passage of a configured time period (see the
reset-time command) without a defect indication. The normal procedure upon
receiving a fault alarm is to inspect the reporting MEP's managed objects using
an appropriate SNMP software tool, diagnose the fault, correct it, re-examine
the MEP's managed objects to see whether the MEP fault notification generator
state machine has been reset, and repeat those steps until the fault is resolved.
Only the highest priority defect currently detected is reported in the fault
alarm.
– 717 –
Chapter 24
Fault Generator Operations
command.
command) has passed with one or more
| CFM Commands
mep fault-notify