Gvrp And Bridge Extension Commands - Edge-Core AS6700-32X Cli Reference Manual

Chapter 18
| VLAN Commands

GVRP and Bridge Extension Commands

GVRP and Bridge Extension Commands
bridge-ext gvrp
GARP VLAN Registration Protocol defines a way for switches to exchange VLAN
information in order to automatically register VLAN members on interfaces across
the network. This section describes how to enable GVRP for individual interfaces
and globally for the switch, as well as how to display default configuration settings
for the Bridge Extension MIB.
Table 91: GVRP and Bridge Extension Commands
Command
bridge-ext gvrp
garp timer
switchport forbidden vlan
switchport gvrp
show bridge-ext
show garp timer
show gvrp configuration
This command enables GVRP globally for the switch. Use the no form to disable it.
Syntax
[no] bridge-ext gvrp
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
GVRP defines a way for switches to exchange VLAN information in order to register
VLAN members on ports across the network. This function should be enabled to
permit automatic VLAN registration, and to support VLANs which extend beyond
the local switch.
Example
Console(config)#bridge-ext gvrp
Console(config)#
Function
Enables GVRP globally for the switch
Sets the GARP timer for the selected function
Configures forbidden VLANs for an interface
Enables GVRP for an interface
Shows the global bridge extension configuration
Shows the GARP timer for the selected function
Displays GVRP configuration for the selected interface
– 468 –
Mode
GC
IC
IC
IC
PE
NE, PE
NE, PE