Ipv6 Pim Propagation-Delay - Edge-Core AS6700-32X Cli Reference Manual

Chapter 30
| Multicast Routing Commands
PIM Multicast Routing
ipv6 pim
propagation-delay
ipv6 pim
trigger-hello-delay
This command configures the propagation delay required for a LAN prune delay
message to reach downstream routers. Use the no form to restore the default
setting.
ipv6 pim propagation-delay milliseconds
no ipv6 pim propagation-delay
milliseconds - The time required for a lan-prune-delay message to reach
downstream routers attached to the same VLAN interface. (Range: 100-
5000 milliseconds)
Default Setting
500 milliseconds
Command Mode
Interface Configuration (VLAN)
Command Usage
The override interval configured by the
the propagation delay configured by this command are used to calculate the LAN
prune delay. If a downstream router has group members which want to continue
receiving the flow referenced in a LAN prune delay message, then the propagation
delay represents the time required for the lan-prune-delay message to be
propagated down from the upstream router to all downstream routers attached to
the same VLAN interface.
Example
Console(config-if)#ipv6 pim propagation-delay 600
Console(config-if)#
Related Commands
ipv6 pim override-interval (1053)
ipv6 pim lan-prune-delay (1052)
This command configures the maximum time before transmitting a triggered PIM
Hello message after the router is rebooted or PIM is enabled on an interface. Use
the no form to restore the default value.
Syntax
ipv6 pim trigger-hello-delay seconds
no ipv6 pim trigger-hello-delay
seconds - The maximum time before sending a triggered PIM Hello
message. (Range: 0-5)
Default Setting
5 seconds
ipv6 pim override-interval
– 1054 –
command and