Ipv4 Commands - Edge-Core AS6700-32X Cli Reference Manual

IPv4 Commands

ip route
Table 164: Global Routing Configuration Commands
Command
show ecmp load-balance
show hash-selection list
1 MAC HS – MAC hash selection.
2 IPv4 HS – IPv4 hash selection.
3 IPv6 HS – IPv6 hash selection
This command configures static routes. Use the no form to remove static routes.
Syntax
ip route destination-ip netmask next-hop [distance]
no ip route {destination-ip netmask next-hop | *}
destination-ip – IP address of the destination network, subnetwork, or host.
netmask - Network mask for the associated IP subnet. This mask identifies
the host address bits used for routing to specific subnets.
next-hop – IP address of the next hop router used for this route.
distance – An administrative distance indicating that this route can be
overridden by dynamic routing information if the distance of the dynamic
route is less than that configured for the static route. Note that the default
administrative distances used by the dynamic unicast routing protocols is
110 for OSPF, 120 for RIP, 20 for eBGP, and 200 for iBGP. (Range: 1-255,
Default: 1)
* – Removes all static routing table entries.
Default Setting
No static routes are configured.
Command Mode
Global Configuration
Command Usage
◆
Up to 512 static routes can be configured.
◆
Up to eight equal-cost multipaths (ECMP) can be configured for static routing
using the maximum-paths
◆
If an administrative distance is defined for a static route, and the same
destination can be reached through a dynamic route at a lower administration
distance, then the dynamic route will be used.
Function
Shows the load-balance method used when there are
multiple equal-cost paths to the same destination
Shows the packet type and hash list attributes
command.
– 803 –
Chapter 29
| IP Routing Commands
Global Routing Configuration
(Continued)
Mode
PE
PE