Set Comm-List Delete - Edge-Core AS6700-32X Cli Reference Manual

Chapter 29
| IP Routing Commands
Policy-based Routing for BGP

set comm-list delete

and that the aggregate path might not be the best path to the destination. This
attribute should be set when the BGP speaker advertises ONLY the less-specific
prefix and suppresses more specific ones.
Example
Console(config)#route-map RD permit 9
Console(config-route-map)#match peer 192.168.0.99
Console(config-route-map)#set atomic-aggregate
Console(config-route-map)#
This command removes communities from the community attribute of inbound or
outbound routing messages. Use the no form to remove this entry from a route
map.
Syntax
[no] set comm-list {1-99 | 100-500 | community-list-name} [delete]
1-99 – Standard community list number that identifies one or more groups
of communities.
100-500 – Expanded community list number that identifies one or more
groups of communities.
community-list-name – Name of standard or expanded community list.
(Maximum length: 32 characters, no spaces or other special characters)
Command Mode
Route Map
Command Usage
When using the ip community-list
each entry of a standard community list should list only one community.
Otherwise, the set comm-list delete command will not succeed. For example, in
order to be able to delete communities 100 and 200, you must create two separate
entries with the ip community-list
Example
Console(config)#route-map RD permit 10
Console(config-route-map)#match peer 192.168.0.77
Console(config-route-map)#set comm-list 10:01 delete
Console(config-route-map)#exit
Console(config)#route-map RD permit 11
Console(config-route-map)#match peer 192.168.0.99
Console(config-route-map)#set comm-list 20:01 delete
Console(config-route-map)#
command to configure a community access list,
command.
– 1004 –