Edge-Core AS6700-32X Cli Reference Manual page 491

Example
Console(config)#dot1q-tunnel system-tunnel-control
Console(config)#interface ethernet 1/1
Console(config-if)#switchport dot1q-tunnel mode access
Console(config-if)#interface ethernet 1/2
Console(config-if)#switchport dot1q-tunnel mode uplink
Console(config-if)#end
Console#show dot1q-tunnel
802.1Q Tunnel Status : Enabled
Port Mode TPID (Hex) Priority Mapping $$$
-------- ------ ---------- ----------------
Eth 1/ 1 Access
Eth 1/ 2 Uplink
Eth 1/ 3 Normal
. .
.
Console#show dot1q-tunnel interface ethernet 1/5
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID Remove C-Tag
-------- ----------- ----- ------------
Eth 1/ 5 1
Default Service
Port Discard
-------- -------- ------------
Eth 1/ 1 Enabled
Console#show dot1q-tunnel service 100
802.1Q Tunnel Service Subscriptions
Port Match C-VID S-VID Remove C-Tag
-------- ----------- ----- ------------
Eth 1/ 5 1
Eth 1/ 6 1
Console#
Related Commands
switchport dot1q-tunnel mode
8100 Disabled
8100 Disabled
8100 Disabled
100 Disabled
Remove C-Tag
Disabled
100 Disabled
100 Enabled
(486)
– 491 –
Chapter 18
| VLAN Commands
Configuring IEEE 802.1Q Tunneling