Event Logging - Edge-Core AS6700-32X Cli Reference Manual

Event Logging

logging facility
This section describes commands used to configure event logging on the switch.
Table 21: Event Logging Commands
Command
logging facility
logging history
logging host
logging on
logging trap
clear log
show log
show logging
This command sets the facility type for remote logging of syslog messages. Use the
no form to return the type to the default.
Syntax
logging facility type
no logging facility
type - A number that indicates the facility used by the syslog server to
dispatch log messages to an appropriate service. (Range: 16-23)
Default Setting
23
Command Mode
Global Configuration
Command Usage
The command specifies the facility type tag sent in syslog messages. (See RFC
3164.) This type has no effect on the kind of messages reported by the switch.
However, it may be used by the syslog server to sort messages or to store messages
in the corresponding database.
Example
Console(config)#logging facility 19
Console(config)#
Chapter 4
Function
Sets the facility type for remote logging of syslog messages GC
Limits syslog messages saved to switch memory based on
severity
Adds a syslog server host IP address that will receive
logging messages
Controls logging of error messages
Limits syslog messages saved to a remote server based on
severity
Clears messages from the logging buffer
Displays log messages
Displays the state of logging
– 153 –
| System Management Commands
Event Logging
Mode
GC
GC
GC
GC
PE
PE
PE