Table 70: show interfaces counters - display description
Parameter
64 Octets
65-127 Octets
128-255 Octets
256-511 Octets
512-1023 Octets
1024-1518 Octets
1519-1536 Octets
Utilization Statistics
Octets input per second
Packets input per second
Input utilization
Octets output per second
Packets output per second
Output utilization
show interfaces
This command displays statistical history for the specified interfaces.
history
Description
The total number of packets (including bad packets) received and
transmitted that were less than 64 octets in length (excluding framing
bits but including FCS octets).
The total number of packets (including bad packets) received and
transmitted where the number of octets fall within the specified range
(excluding framing bits but including FCS octets).
Number of octets entering this interface in kbits per second.
Number of packets entering this interface in packets per second.
The input utilization rate for this interface.
Number of octets leaving this interface in kbits per second.
Number of packets leaving this interface in packets per second.
The output utilization rate for this interface.
show interfaces history [interface [name [current |
previous index count] [input | output]]]
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-32/54)
port-channel channel-id (Range: 1-16/27)
name - Name of sample as defined in the
(Range: 1-32 characters)
current - Statistics recorded in current interval.
previous - Statistics recorded in previous intervals.
index - An index into the buckets containing previous samples.
(Range: 1-96)
count - The number of historical samples to display. (Range: 1-96)
input - Ingress traffic.
output - Egress traffic.
– 373 –
Chapter 10
| Interface Commands
Interface Configuration
(Continued)
history
command.