Show Ip Igmp Snooping Mrouter - Edge-Core AS6700-32X Cli Reference Manual

Command Mode
Global Configuration
Command Usage
Depending on your network connections, IGMP snooping may not always be able
to locate the IGMP querier. Therefore, if the IGMP querier is a known multicast
router/switch connected over the network to an interface (port or trunk) on your
router, you can manually configure that interface to join all the current multicast
groups.
Example
The following shows how to configure port 11 as a multicast router port within
VLAN 1:
show ip igmp
This command displays information on statically configured and dynamically
snooping mrouter learned multicast router ports.
Syntax
Default Setting
Displays multicast router ports for all configured VLANs.
Command Mode
Privileged Exec
Command Usage
Multicast router port types displayed include Static or Dynamic.
Example
The following shows that port 11 in VLAN 1 is attached to a multicast router:
Console(config)#ip igmp snooping vlan 1 mrouter ethernet 1/11
Console(config)#
show ip igmp snooping mrouter [vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Console#show ip igmp snooping mrouter vlan 1
VLAN M'cast Router Ports Type
---- ------------------- -------
1 Eth 1/11
2 Eth 1/12
Console#
– 1021 –
Chapter 30
Static
Dynamic
| Multicast Routing Commands
Static Multicast Routing