Table 34: Static Multicast Routing Commands - Edge-Core ECS4620-28P Cli Reference Manual

Static Multicast Routing
ip igmp snooping vlan
mrouter
This example lists all entries in the multicast table in summary form:
Console#show ipv6 mroute summary
IP Multicast Forwarding is disabled
IP Multicast Routing Table (Summary)
Flags: F - Forwarding, P - Pruned, D - PIM-DM, S – PIM-SM, V – DVMRP,
M - MLD
Group
------------------------------ ------------------------------ ---------- ----
Total Entry is 1
Console#
This section describes commands used to configure static multicast routes on the
switch.

Table 34: Static Multicast Routing Commands

Command
ip igmp snooping vlan
mrouter
show ip igmp snooping
mrouter
This command statically configures a multicast router port. Use the no form to
remove the configuration.
Syntax
ip igmp snooping vlan vlan-id mrouter interface
no ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4094)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1-8)
port - Port number. (Range: 1-28/52)
port-channel channel-id (Range: 1-16)
Default Setting
No static multicast router ports are configured.
Chapter 51
Source
FF02::0101
Function
Adds a multicast router port
Shows multicast router ports
– 1181 –
| Multicast Routing Commands
Static Multicast Routing
Interface Flag
FE80::0101 VLAN 4096
Mode
GC
PE
DF