Ipv6 Acls - Edge-Core AS6700-32X Cli Reference Manual

Chapter 9
| Access Control Lists

IPv6 ACLs

IPv6 ACLs
access-list ipv6
Example
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 255.255.15.0
Console#
Related Commands
permit, deny (337)
ip access-group (340)
The commands in this section configure ACLs based on IPv6 address, DSCP traffic
class, next header type, or flow label. To configure IPv6 ACLs, first create an access
list containing the required permit or deny rules, and then bind the access list to
one or more ports.
Table 65: IPv6 ACL Commands
Command
access-list ipv6
permit, deny
permit, deny
show ipv6 access-list
ipv6 access-group
show ipv6 access-group
This command adds an IP access list and enters configuration mode for standard or
extended IPv6 ACLs. Use the no form to remove the specified ACL.
Syntax
[no] access-list ipv6 {standard | extended} acl-name
standard – Specifies an ACL that filters packets based on the source IP
address.
extended – Specifies an ACL that filters packets based on the destination IP
address, and other more specific criteria.
acl-name – Name of the ACL. (Maximum length: 32 characters)
Default Setting
None
Function
Creates an IPv6 ACL and enters configuration mode for
standard or extended IPv6 ACLs
Filters packets matching a specified source IPv6 address IPv6- STD-ACL
Filters packets meeting a specified criteria, including
destination IPv6 address
Displays the rules for configured IPv6 ACLs
Adds a port to an IPv6 ACL
Shows port assignments for IPv6 ACLs
– 342 –
Mode
GC
IPv6- EXT-ACL
PE
IC
PE