Network - Edge-Core AS6700-32X Cli Reference Manual

network

This command specifies the network interfaces that will be included in the RIP
routing process. Use the no form to remove an entry.
Syntax
[no] network {ip-address netmask | vlan vlan-id}
ip-address – IP address of a network directly connected to this router.
netmask - Network mask for the route. This mask identifies the network
address bits used for the associated routing entries.
vlan-id - VLAN ID. (Range: 1-4094)
Default Setting
No networks are specified.
Command Mode
Router Configuration
Command Usage
◆
RIP only sends and receives updates on interfaces specified by this command. If
a network is not specified, the interfaces in that network will not be advertised
in any RIP updates.
◆
Subnet addresses are interpreted as class A, B or C, based on the first field in the
specified address. In other words, if a subnet address nnn.xxx.xxx.xxx is entered,
the first field (nnn) determines the class:
0 - 127 is class A, and only the first field in the network address is used.
128 - 191 is class B, and the first two fields in the network address are used.
192 - 223 is class C, and the first three fields in the network address are used.
Example
This example includes network interface 10.1.0.0 in the RIP routing process.
Console(config-router)#network 10.1.0.0
Console(config-router)#
Related Commands
router rip (820)
– 825 –
Chapter 29
| IP Routing Commands
Routing Information Protocol (RIP)