Chapter 11
| Link Aggregation Commands
Manual Configuration Commands
channel-group
router trunk links where traffic through the switch is received from and
destined for many different hosts.
src-dst-mac: All traffic with the same source and destination MAC address
■
is output on the same link in a trunk. This mode works best for switch-to-
switch trunk links where traffic through the switch is received from and
destined for many different hosts.
src-ip: All traffic with the same source IP address is output on the same link
■
in a trunk. This mode works best for switch-to-router or switch-to-server
trunk links where traffic through the switch is received from many different
hosts.
src-mac: All traffic with the same source MAC address is output on the
■
same link in a trunk. This mode works best for switch-to-switch trunk links
where traffic through the switch is received from many different hosts.
Example
Console(config)#port-channel load-balance dst-ip
Console(config)#
This command adds a port to a trunk. Use the no form to remove a port from a
trunk.
Syntax
channel-group channel-id
no channel-group
channel-id - Trunk index (Range: 1-16/27)
Default Setting
The current port will be added to this trunk.
Command Mode
Interface Configuration (Ethernet)
Command Usage
◆
When configuring static trunks, the switches must comply with the Cisco
EtherChannel standard.
◆
Use no channel-group to remove a port group from a trunk.
◆
Use
no interface port-channel
to remove a trunk from the switch.
– 392 –