Edge-Core AS6700-32X Cli Reference Manual page 683

Table 133: CFM Commands
Command
ethernet cfm mep
crosscheck
show ethernet cfm
maintenance-points
remote crosscheck
Link Trace Operations
ethernet cfm linktrace
cache
ethernet cfm linktrace
cache hold-time
ethernet cfm linktrace
cache size
ethernet cfm linktrace
clear ethernet cfm
linktrace-cache
show ethernet cfm
linktrace-cache
Loopback Operations
ethernet cfm loopback
Fault Generator Operations
mep fault-notify alarm-time
mep fault-notify lowest-
priority
mep fault-notify reset-time
show ethernet cfm fault-
notify-generator
Delay Measure Operations
ethernet cfm delay-
measure two-way
Basic Configuration Steps for CFM
1.
Configure the maintenance domains with the
2.
Configure the maintenance associations with the
3.
Configure the local maintenance end points (MEPs) which will serve as the
domain service access points for the specified maintenance association using
the ethernet cfm mep
(Continued)
Function
Enables cross-checking between the list of configured
remote MEPs within a maintenance association and MEPs
learned through continuity check messages
Displays information about remote maintenance points
configured statically in a cross-check list
Enables caching of CFM data learned through link trace
messages
Sets the hold time for CFM link trace cache entries
Sets the maximum size for the link trace cache
Sends CFM link trace messages to the MAC address for a
MEP
Clears link trace messages logged on this device
Displays the contents of the link trace cache
Sends CFM loopback messages to a MAC address for a MEP
or MIP
Sets the time a defect must exist before a fault alarm is
issued
Sets the lowest priority defect that is allowed to generate a
fault alarm
Configures the time after a fault alarm has been issued, and
no defect exists, before another fault alarm can be issued
Displays configuration settings for the fault notification
generator
Sends periodic delay-measure requests to a specified MEP
within a maintenance association
command.
– 683 –
Chapter 24
| CFM Commands
Mode
PE
PE
GC
GC
GC
PE
PE
PE
PE
CFM
CFM
CFM
PE
PE
ethernet cfm domain command.
ma index name command.