Ipv6 Mld Max-Resp-Interval - Edge-Core AS6700-32X Cli Reference Manual

Chapter 22
| Multicast Filtering Commands
MLD (Layer 3)
ipv6 mld
max-resp-interval
Default Setting
10 (1 second)
Command Mode
Interface Configuration (VLAN)
Command Usage
When the switch receives an MLD or MLDv2 leave message from a host that wants
to leave a multicast group, source or channel, it sends a number of group-specific
or group-source-specific query messages at intervals defined by this command. If
no response is received after this period, the switch stops forwarding for the group,
source or channel.
Example
Console(config)#interface vlan 1
Console(config-if)#ipv6 mld last-member-query-response-interval 20
Console(config-if)#
This command configures the maximum response time advertised in MLD queries.
Use the no form of this command to restore the default setting.
Syntax
ipv6 mld max-resp-interval seconds
no ipv6 mld max-resp-interval
seconds - The report delay advertised in MLD queries.
(Range: 0-255 tenths of a second)
Default Setting
100 (10 seconds)
Command Mode
Interface Configuration (VLAN)
Command Usage
◆
By varying the Maximum Response Interval, the burstiness of MLD messages
passed on the subnet can be tuned; where larger values make the traffic less
bursty, as host responses are spread out over a larger interval.
◆
The number of seconds represented by the maximum response interval must
be less than the Query Interval (page 643).
– 642 –