Ip Igmp Max-Resp-Interval - Edge-Core AS6700-32X Cli Reference Manual

Chapter 22
| Multicast Filtering Commands
IGMP (Layer 3)
ip igmp
max-resp-interval
This command configures the maximum response time advertised in IGMP queries.
Use the no form of this command to restore the default.
Syntax
ip igmp max-resp-interval seconds
no ip igmp max-resp-interval
seconds - The report delay advertised in IGMP queries.
(Range: 0-255 tenths of a second)
Default Setting
100 (10 seconds)
Command Mode
Interface Configuration (VLAN)
Command Usage
◆
IGMPv1 does not support a configurable maximum response time for query
messages. It is fixed at 10 seconds for IGMPv1.
◆
By varying the Maximum Response Interval, the burstiness of IGMP messages
passed on the subnet can be tuned; where larger values make the traffic less
bursty, as host responses are spread out over a larger interval.
◆
The number of seconds represented by the maximum response interval must
be less than the Query Interval
Example
The following shows how to configure the maximum response time to 20 seconds.
Console(config-if)#ip igmp query-max-response-time 200
Console(config-if)#
Related Commands
ip igmp version (633)
ip igmp query-interval (631)
(page 631).
– 630 –