Show Ipv6 Pim Neighbor - Edge-Core AS6700-32X Cli Reference Manual

Chapter 30
| Multicast Routing Commands
PIM Multicast Routing
show ipv6 pim
neighbor
PIM6-DM Commands
ipv6 pim graft-retry-
interval
This command displays information about PIM neighbors.
Syntax
show ipv6 pim neighbor [interface vlan vlan-id]
vlan-id - VLAN ID (Range: 1-4094)
Default Setting
Displays information for all known PIM neighbors.
Command Mode
Normal Exec, Privileged Exec
Example
Console#show ipv6 pim neighbor
Neighbor Address
--------------------------------------- -------------- -------- -------- ---
FF80::0101
FF80::0202
Console#
Table 206: show ipv6 pim neighbor - display description
Field
Neighbor Address
VLAN Interface
Uptime
Expiration Time
DR
This command configures the time to wait for a Graft acknowledgement before
resending a Graft. Use the no form to restore the default value.
Syntax
ipv6 pim graft-retry-interval seconds
no ipv6 pim graft-retry-interval
seconds - The time before resending a Graft. (Range: 1-10 seconds)
Default Setting
3 seconds
VLAN Interface Uptime
VLAN 1
VLAN 2
Description
IP address of the next-hop router.
Interface number that is attached to this neighbor.
The duration this entry has been active.
The time before this entry will be removed.
The designated PIM6-SM router. If multicast hosts are directly
connected to the LAN, then only one of these routers is elected as the
DR, and acts on behalf of these hosts, sending periodic Join/Prune
messages toward a group-specific RP for each group.
– 1056 –
Expire DR
00:01:23 00:01:23 YES
1d 11h Never