Mac Acls - Edge-Core AS6700-32X Cli Reference Manual

MAC ACLs

access-list mac
Related Commands
permit, deny (Standard IPv6 ACL) (343)
permit, deny (Extended IPv6 ACL) (344)
ipv6 access-group (345)
The commands in this section configure ACLs based on hardware addresses, packet
format, and Ethernet type. To configure MAC ACLs, first create an access list
containing the required permit or deny rules, and then bind the access list to one or
more ports.
Table 66: MAC ACL Commands
Command
access-list mac
permit, deny
mac access-group
show mac access-group
show mac access-list
This command adds a MAC access list and enters MAC ACL configuration mode.
Rules can be added to filter packets matching a specified MAC source or
destination address (i.e., physical layer address), or Ethernet protocol type. Use the
no form to remove the specified ACL.
Syntax
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
◆
When you create a new ACL or enter configuration mode for an existing ACL,
use the permit or deny command to add new rules to the bottom of the list.
◆
To remove a rule, use the no permit or no deny command followed by the
exact text of a previously configured rule.
Function
Creates a MAC ACL and enters configuration mode
Filters packets matching a specified source and destination
address, packet format, and Ethernet type
Binds a MAC ACL to a port
Shows port assignments for MAC ACLs
Displays the rules for configured MAC ACLs
– 347 –
Chapter 9
| Access Control Lists
MAC ACLs
Mode
GC
MAC-ACL
IC
PE
PE