Removing And Replacing Consumable Parts; Removing And Replacing Structural Parts; Removing The Server Top Cover - IBM System x3750 M4 Installation And Service Manual

Types 8722 and 8733

Hide thumbs Also See for System x3750 M4:

Table of Contents

Removing and replacing consumable parts

This information covers removing and replacing consumable parts.

Replacement of consumable parts is your responsibility. If IBM installs a

consumable part at your request, you will be charged for the installation.

The illustrations in this document might differ slightly from your hardware.

This information covers the process for removing and replacing structural parts.

Replacement of structural parts is your responsibility. If IBM installs a structural

part at your request, you will be charged for the installation.

The illustrations in this document might differ slightly from your hardware.

This information provides instructions on how to remove the server top cover.

About this task

To remove the server top cover, complete the following steps:

1. Read the safety information and installation guidelines, see "Safety" on page vii

2. Turn off the server (see "Turning off the server" on page 22) and all attached

3. If the server has been installed in a rack, slide the server out from the rack

4. Press in on the blue tab on the cover-release latch and lift the cover release

System x3750 M4 Types 8722 and 8733: Installation and Service Guide

and "Installation guidelines" on page 35.

peripheral devices. Disconnect all power cords; then, disconnect all external

cables as necessary to replace the device.

Note: If you need to view any LEDs on the system board after you disconnect

power, press the Light path button to light the LEDs.

latch up (the cover slides to the rear). Lift the cover off the server and set it